Quality in IOT design

A team of specialists uses all its know-how to design your project. And supports you in all the stages of your project , from the feasibility phase to the design of your connected object ( IoT ).

The methods that have been described (staking, configuration management, control of efficiency and costs, control of important characteristics such as reliability and maintainability) make it possible to organize the implementation of a new product more rationally. But the error is expensive, the more expensive it occurs earlier, it is not detected immediately, and the correction takes a long time to define and then take effect.

We must therefore go even further, create a permanent climate of fight against “non-quality” and put in place, in development plans, actions of protest which will make it possible, if not to avoid, at least to greatly reduce later setbacks. Among the tools available are:

– For the feasibility phases:

  • The “concept review”

– For the options and development phases:

  • Definition review
  • Feasibility forecast
  • Analysis of failure modes, their effects and criticality (FMEA);

– For the development phase:

  • Prototype testing,
  • Overload prototype testing
  • Accelerated testing
  • Environmental testing
  • The qualification

– For the production phase:

  • Tests by the manufacturer
  • Tests by particular users, or by “panels”,
  • Commissioning on a limited scale, for example in a given region;

– For all phases

  • Collection and analysis of quality information,
  • Failure analysis,
  • Audits

For a new product, the most important source of failure is weaknesses in the definition . As development and product definition precede its use by several years, it is very important to uncover the weaknesses of the definition as early as the development phase . Otherwise the damage caused by these weaknesses is multiplied enormously …